Sciact
  • EN
  • RU

Design of Pt-Sn Catalysts on Mesoporous Titania Films for Microreactor Application Научная публикация

Конференция 3rd International Conference on Structured Catalysts and Reactors
27-30 сент. 2009 , Ischia
Журнал Catalysis Today
ISSN: 0920-5861 , E-ISSN: 1873-4308
Вых. Данные Год: 2009, Том: 147, Страницы: S81-S86 Страниц : 7 DOI: 10.1016/j.cattod.2009.07.046
Ключевые слова Citral hydrogenation, Mesoporous titania, Mixed-metal clusters, Pt-Sn
Авторы Ismagilov Z.R. 1 , Matus E.V. 1 , Yakutova A.M. 1 , Protasova L.N. 1,2 , Ismagilov I.Z. 1 , Kerzhentsev M.A. 1 , Rebrov E.V. 2 , Schouten J.C. 2
Организации
1 Boreskov Institute of Catalysis, Novosibirsk, 630090, Russia
2 Eindhoven University of Technology, Eindhoven, P.O. Box 513, 5600 MB, The Netherlands

Информация о финансировании (1)

1 Netherlands Organisation for Scientific Research 047.017.028

Реферат: A new generation of nanostructured Pt–Sn/TiO2 catalytic thin films has been developed by deposition of Pt–Sn mixed-metal precursors from organic solvents on mesoporous TiO2/Ti films with a thickness of 200–300 nm. The titania sol was obtained by templating a TiO2 precursor with Pluronic F127 surfactant. The films were prepared on Ti substrates by spin-coating. The influence of the F127/Ti ratio in the range between 0.006 and 0.050, the pH of the titania sol between 1.5 and 2.0, and the aging time between 8 and 240 h on the morphology and porous structure of titania films was investigated. A TiO2 film with the highest degree of the long-order structure was obtained at a surfactant/Ti molar ratio of 0.009, a pH of 1.5, and an aging time of 24 h. This film has a hexagonal pore structure with a mean pore size of 3.5 nm and a porosity of 25%. A powder titania support with a similar chemical composition and morphology was also produced and used for optimization of an active component deposition. The Pt–Sn carbonyl [Pt3(CO)3(SnCl3)2(SnCl2·H2O)]n−2n clusters were synthesized separately from monometallic precursors. They were loaded onto the TiO2 supports by impregnation or adsorption. The adsorption of the Pt–Sn precursor for 24 h from an ethanol solution with concentrations of Pt and Sn of 2.0 and 1.2 mg/ml, respectively, followed by a vacuum treatment at 463 K, resulted in Pt–Sn nanoparticles embedded in the mesoporous titania network. An average size of bimetallic nanoparticles was 1.5–2 nm with a narrow particle size distribution. A reaction rate in terms of TOF between 0.2 and 3.3 min−1 was observed in the hydrogenation of citral over the Pt–Sn/TiO2 catalysts. The selectivity to the unsaturated alcohols was as high as 90% at a citral conversion above 95%.
Библиографическая ссылка: Ismagilov Z.R. , Matus E.V. , Yakutova A.M. , Protasova L.N. , Ismagilov I.Z. , Kerzhentsev M.A. , Rebrov E.V. , Schouten J.C.
Design of Pt-Sn Catalysts on Mesoporous Titania Films for Microreactor Application
Catalysis Today. 2009. V.147. P.S81-S86. DOI: 10.1016/j.cattod.2009.07.046 WOS Scopus РИНЦ CAPlusCA OpenAlex
Даты:
Опубликована online: 4 авг. 2009 г.
Опубликована в печати: 1 сент. 2009 г.
Идентификаторы БД:
Web of science: WOS:000269990800015
Scopus: 2-s2.0-69249221222
РИНЦ: 15310952
Chemical Abstracts: 2009:1074966
Chemical Abstracts (print): 151:493330
OpenAlex: W2158202316
Цитирование в БД:
БД Цитирований
Web of science 30
Scopus 31
РИНЦ 34
OpenAlex 32
Альметрики: