Реферат: Scanning electron microscopy and energy-dispersive X-ray spectroscopy were used to study microstructure, morphology and chemical composition of the surface and near-surface layers of polycrystalline wire of commercial platinoid gauzes containing Pt (81 wt %), Pd (15 wt %), Rh (3.5 wt %), and Ru (0.5 wt %) after ammonia oxidation (10 vol % NH3) by air at 1133 K for 50 h in the presence of these gauzes. Upon the completion of the catalytic reaction of ammonia oxidation, reconstruction (catalytic etching) of the surface layer on the backside of gauze wire (in the direction of the gas flow) was observed, in which the regions with different degrees of etching were identified. The analysis of these regions showed that the catalytic etching of the platinoid wire is initiated by etching the surface layer in the region of grain boundaries and dislocations in the course of highly exothermic catalytic reaction of ammonia oxidation by oxygen penetrated in the regions of defects. The regions with minimal etching contain smooth grains with crystalline terraces, 50 nm high, and with etching pits with size of ~72 nm in a concentration of 4.2 × 108 cm–2. The region with medium etching includes rough grains with etching pits with size of ~85 nm in a concentration of 2.5 × 108 cm–2. The regions with maximal etching consist of recrystallized grains with large pores with sizes of 350–400 nm in concentration of 8.9 × 106 cm–2. These grains are separated by voids with a width of 1–5 μm and a depth of 10 μm, which increases the specific surface area in the surface layer of wire. The growth of the specific surface area of the platinoid wire is accompanied by an increase in the volume rate of ammonia oxidation and, as a result, local overheating due to the high exothermicity of the reaction. With increasing temperature, the rate of diffusion of metal atoms increases, which, in turn, accelerates etching in this region. These processes lead to increasing the region of etching along the wire, which points to the autocatalytic regime of etching of platinoid gauzes in ammonia oxidation by oxygen.

Библиографическая ссылка: Salanov A.N. , Suprun E.A. , Serkova A.N. , Kochurova N.M. , Sidel’nikova O.N. , Sutormina E.F. , Isupova L.A. , Parmon V.N.
Catalytic Etching of Platinoid Gauzes During the Oxidation of Ammonia by Air. Reconstruction of the Surface of a Platinoid Gauze Backside in the Course of Ammonia Oxidation at 1133 K
Kinetics and Catalysis. 2018. V.59. N6. P.792-809. DOI: 10.1134/S0023158418060137 WOS Scopus РИНЦ CAPlus OpenAlex

Оригинальная: Саланов А.Н. , Супрун Е.А. , Серкова А.Н. , Кочурова Н.М. , Сидельникова О.Н. , Сутормина Е.Ф. , Исупова Л.А. , Пармон В.Н.
Каталитическая коррозия платиноидных сеток при окислении аммиака воздухом. Реконструкция поверхности тыльной стороны платиноидной сетки в ходе окисления NH3 при 1133 K
Кинетика и катализ. 2018. Т.59. №6. С.756-775. DOI: 10.1134/S0453881118060175 РИНЦ OpenAlex

Даты:

Поступила в редакцию:	20 апр. 2018 г.
Опубликована в печати:	1 нояб. 2018 г.
Опубликована online:	4 мар. 2019 г.

Идентификаторы БД:

Web of science:	WOS:000460765200012
Scopus:	2-s2.0-85062594209
РИНЦ:	38679935
Chemical Abstracts:	2019:795065
OpenAlex:	W2920618470

Цитирование в БД:

БД	Цитирований
Scopus	6
Web of science	6
РИНЦ	4
OpenAlex	5

Альметрики: