Sciact
  • EN
  • RU

An XPS Investigation of CO Titration of Oxygen from an Ir(111) Surface Full article

Journal Applications of Surface Science (Continued as Applied Surface Science)
ISSN: 0378-5963
Output data Year: 1979, Volume: 3, Number: 2, Pages: 145-160 Pages count : 16 DOI: 10.1016/0378-5963(79)90015-1
Tags OXYGEN - Adsorption; SURFACES - Spectroscopic Analysis
Authors Zhdan P.A. 1 , Boreskov G.K. 1 , Boronin A.I. 1 , Schepelin A.P. 1 , Withrow S.P. 2 , Weinberg W.H. 2
Affiliations
1 Institute of Catalysis of the Academy of Sciences of the USSR, Novosibirsk 630090, USSR
2 Division of Chemistry and Chemical Engineering, California Institute of Technology, Pasadena, California 91125, USA

Funding (3)

1 National Science Foundation CHE77-10629A01
2 Alfred P. Sloan Foundation
3 Camille and Henry Dreyfus Foundation

Abstract: The CO oxidation reaction has been studied under UHV conditions in experiments involving the titration of pre-adsorbed oxygen from an Ir(111) surface by CO. The reaction has been carried out at crystal temperatures between 310 and 545 K and CO partial pressures between 2 × 10−9 Torr and 2 × 10−7 Torr. Time dependent surface coverages of oxygen and CO have been monitored using X-ray photoelectron spectroscopy and have been used to test proposed reaction mechanisms. Under the experimental conditions employed here, the reaction appears to occur between chemisorbed oxygen and surface CO. At temperatures below 350 K, the reaction can be described by the rate expression RCO2 = k0[O]FCOexp(−EakT), where RCO2 is the rate of CO2 production, k0 is the pre-exponential factor of the reaction rate coefficient, [O] is the surface concentration of oxygen, FCO is the incident flux of CO, and Ea is the activation energy for the reaction. Ea and k0 are found to be 7.8 ± 1.0 kcal⧸mole and 3.2 ± 1.5 × 10−12 cm2, respectively. While this expression is of the Eley-Rideal form, which can describe a reaction mechanism in which CO reacts on impact from the ambient, the high values for the kinetic parameters obtained indicate something more complicated than an impact reaction is undoubtedly occuring at these low temperatures. An alternative, surface reaction involving weakly bound CO is suggested. At temperatures above 450 K, the dominant reaction can be described by a reaction rate expression of the form RWCO2 = kW0[O](1−θO)FCOexp(−EWakT), where (1−θO) is the fraction of empty surface sites (θO is the fractional oxygen coverage) available for CO adsorption. The superscripts are used to differentiate this reaction from that occurring at lower temperatures. EWa and kW0 are 1.2 ± 0.4 kcal⧸mole and 2.3 ± 2.5 × 10−14 cm2, respectively. At temperatures between 350 K and 450 K a model is suggested which incorporates both mechanisms.
Cite: Zhdan P.A. , Boreskov G.K. , Boronin A.I. , Schepelin A.P. , Withrow S.P. , Weinberg W.H.
An XPS Investigation of CO Titration of Oxygen from an Ir(111) Surface
Applications of Surface Science (Continued as Applied Surface Science). 1979. V.3. N2. P.145-160. DOI: 10.1016/0378-5963(79)90015-1 WOS Scopus РИНЦ ANCAN OpenAlex
Dates:
Submitted: Jan 19, 1978
Accepted: Jan 10, 1979
Published print: Sep 1, 1979
Published online: Oct 9, 2002
Identifiers:
Web of science: WOS:A1979HF89100002
Scopus: 2-s2.0-0018515825
Elibrary: 41734147
Chemical Abstracts: 1979:529593
Chemical Abstracts (print): 91:129593
OpenAlex: W2095454976
Citing:
DB Citing
Web of science 11
Scopus 10
Elibrary 10
OpenAlex 10
Altmetrics: