Реферат: Mechanochemical pre-treatment of the initial powder or addition of a binding agent (aq. Al oxynitrate) allows forming of catalysts from CuO powders prepared by thermal decomposition of malachite. The resulting increase in catalyst granule stability produces an increase in catalyst stability. The Al oxynitrate binder lowers catalyst stability by blocking CaO active surface sites (dislocation defects). Calcination at ≤973 K causes sintering and a decrease in the no. of active sites; this decreases catalyst activity. Introduction of Al2O3 enhances catalyst thermal stability. The optimum catalysts contain ≤10% Al2O3 and are formed into granules by mechanochemical activation of the powder and subsequent binding with H2O.

Библиографическая ссылка: Isupova L.A. , Aleksandrov V.Y. , Popovskii V.V. , Moroz E.M.
Influence of the Preparation Conditions on the Properties of Copper Oxide Catalysts for Intensive Oxidation
Journal of Applied Chemistry of the USSR (after 1983 - Russian Journal of Applied Chemistry). 1988. V.61. N9-1. P.1788-1791. WOS РИНЦ

Оригинальная: Исупова Л.А. , Александров В.Ю. , Поповский В.В. , Мороз Э.М.
Влияние условий приготовления на свойства оксидномедных катализаторов глубокого окисления
Журнал прикладной химии. 1988. Т.61. №9. С.1976-1980. РИНЦ CAPlusCA

Даты:

Поступила в редакцию:	16 мар. 1987 г.
Опубликована в печати:	1 сент. 1988 г.

Идентификаторы БД:

Web of science:	WOS:A1988AB30200006
РИНЦ:	31487486

Цитирование в БД: Пока нет цитирований