Sciact
  • EN
  • RU

Investigation of Oxygen States and Reactivities on a Nanostructured Cupric Oxide Surface Full article

Journal Applied Surface Science
ISSN: 0169-4332
Output data Year: 2011, Volume: 257, Number: 20, Pages: 8542-8549 Pages count : 8 DOI: 10.1016/j.apsusc.2011.05.012
Tags CO oxidation, Copper (II) oxide, Nanoparticles, Oxygen species, RF discharge, STM, XPS
Authors Svintsitskiy D.A. 1,2 , Stadnichenko A.I. 1,2 , Demidov D.V. 1 , Koscheev S.V. 1 , Boronin A.I. 1,2
Affiliations
1 Boreskov Institute of Catalysis SB RAS, Prospect Akademika Lavrentieva 5, Novosibirsk 630090, Russia
2 Novosibirsk State University, 630090, Pirogova Street 2, Novosibirsk, Russia

Funding (3)

1 Russian Foundation for Basic Research 10-03-00843
2 The Ministry of Education and Science of the Russian Federation P-698
3 Zamaraev International Charitable Scientific Foundation

Abstract: Nanostructured copper (II) oxide was formed on clean copper foil at room temperature using activated oxygen produced by RF discharge. CuO particles of approximately 10–20 nm were observed on the surface by Scanning Tunneling Microscopy (STM). The copper states and oxygen species of the model cupric oxide were studied by means of X-ray Photoelectron Spectroscopy (XPS). These oxide particles demonstrated abnormally high reactivity with carbon monoxide (CO) at temperatures below 100 °C. The XPS data showed that the interaction of CO with the nanostructured cupric oxide resulted in reduction of the CuO particles to Cu2O species. The reactivity of the nanostructured cupric oxide to CO was studied at 80 °C using XPS in step-by-step mode. The initial reactivity was estimated to be 5 × 10−5 and was steadily reduced down to 5 × 10−9 as the exposure was increased. O1s spectral analysis allowed us to propose that the high initial reactivity was caused by the presence of non-lattice oxygen states on the surface of the nanostructured CuO. We established that reoxidation of the partially reduced nanostructured cupric oxide by molecular oxygen O2 restored the highly reactive oxygen form on the surface. These results allowed us to propose that the nanostructured cupric oxide could be used for low temperature catalytic CO oxidation. Some hypotheses concerning the nature of the non-lattice oxygen species with high reactivity are also discussed.
Cite: Svintsitskiy D.A. , Stadnichenko A.I. , Demidov D.V. , Koscheev S.V. , Boronin A.I.
Investigation of Oxygen States and Reactivities on a Nanostructured Cupric Oxide Surface
Applied Surface Science. 2011. V.257. N20. P.8542-8549. DOI: 10.1016/j.apsusc.2011.05.012 WOS Scopus РИНЦ ANCAN OpenAlex
Dates:
Submitted: Dec 30, 2010
Accepted: May 3, 2011
Published online: May 11, 2011
Published print: Aug 1, 2011
Identifiers:
Web of science: WOS:000291725100043
Scopus: 2-s2.0-80955177138
Elibrary: 18013444
Chemical Abstracts: 2011:767130
Chemical Abstracts (print): 155:224611
OpenAlex: W2034789886
Citing:
DB Citing
Web of science 93
Scopus 95
Elibrary 89
OpenAlex 96
Altmetrics: