Sciact
  • EN
  • RU

Selective Hydrogenation of 5-Acetoxymethylfurfural over Cu-Based Catalysts in a Flow Reactor: Effect of Cu-Al Layered Double Hydroxides Synthesis Conditions on Catalytic Properties Научная публикация

Журнал Catalysts
ISSN: 2073-4344
Вых. Данные Год: 2022, Том: 12, Номер: 8, Номер статьи : 878, Страниц : 14 DOI: 10.3390/catal12080878
Ключевые слова Cu-based catalysts; layered double hydroxides; catalyst preparation; selective hydrogenation; 5-Acetoxymethylfurfural; flow reactor; heterogeneous catalysis
Авторы Bukhtiyarova Marina V. 1 , Bulavchenko Olga A. 1 , Bukhtiyarov Andrey V. 1 , Nuzhdin Alexey L. 1 , Bukhtiyarova Galina A. 1
Организации
1 Boreskov Institute of Catalysis SB RAS, 630090 Novosibirsk, Russia

Информация о финансировании (1)

1 Министерство науки и высшего образования Российской Федерации (с 15 мая 2018) 0239-2021-0008

Реферат: Cu-containing layered double hydroxides (LDHs) were synthesized by a co-precipitation method at different reaction conditions, such as aging time, pH, precipitation rate and synthesis temperature. The effect of these parameters on the structure and chemical composition of the catalysts were investigated using a set of physical methods, including thermogravimetric analysis (TGA), X-ray diffraction (XRD), H-2-TPR and in situ X-ray photoelectron spectroscopy (XPS). It allowed for checking of the reducibility of the samples. 5-Acetoxymethylfurfural was catalytically hydrogenated to 5-(acetoxymethyl)-2-furanmethanol (AMFM) over Cu-containing catalysts synthesized from layered double hydroxides so as to investigate its catalytic properties in flow reaction. It was shown that synthesis pH decreasing from 10 to 8 resulted in rise of AMF conversion that coincided with the higher surface Cu/Al ratio obtained by XPS. Preferable aging time of LDH materials for obtaining the most active catalyst was 2 h, an amount of time that favored the production of the catalyst with high surface Cu/Al ratio up to 0.38. Under optimized reaction conditions, the AMFM yield was 98%. Finally, a synthesis strategy for the preparation of highly efficient Cu-based hydrogenation catalyst with optimized characteristics is suggested.
Библиографическая ссылка: Bukhtiyarova M.V. , Bulavchenko O.A. , Bukhtiyarov A.V. , Nuzhdin A.L. , Bukhtiyarova G.A.
Selective Hydrogenation of 5-Acetoxymethylfurfural over Cu-Based Catalysts in a Flow Reactor: Effect of Cu-Al Layered Double Hydroxides Synthesis Conditions on Catalytic Properties
Catalysts. 2022. V.12. N8. 878 :1-14. DOI: 10.3390/catal12080878 WOS Scopus РИНЦ OpenAlex CAPlus
Даты:
Поступила в редакцию: 28 июн. 2022 г.
Принята к публикации: 8 авг. 2022 г.
Опубликована в печати: 10 авг. 2022 г.
Опубликована online: 10 сент. 2022 г.
Идентификаторы БД:
≡ Web of science: WOS:000847070600001
≡ Scopus: 2-s2.0-85137370458
≡ РИНЦ: 52253280
≡ OpenAlex: W4290988407
≡ Chemical Abstracts: 2022:2264042
Цитирование в БД:
≡ Web of science 11 Сбор данных от 20.02.2026
≡ Scopus 13 Сбор данных от 15.02.2026
≡ РИНЦ 9 Сбор данных от 15.02.2026
≡ OpenAlex 12 Сбор данных от 15.02.2026
Альметрики: