A Carbon Nanotube Film as a Radio Frequency Filter
Научная публикация
Общее |
Язык:
Английский,
Жанр:
Статья (Full article),
Статус опубликования:
Опубликована,
Оригинальность:
Оригинальная
|
Журнал |
Carbon
ISSN: 0008-6223
, E-ISSN: 1873-3891
|
Вых. Данные |
Год: 2005,
Том: 43,
Номер: 9,
Страницы: 1815-1819
Страниц
: 5
DOI:
10.1016/j.carbon.2005.02.012
|
Ключевые слова |
Carbon nanotubes, Chemical vapor deposition, Electrical (electronic) properties |
Авторы |
Prokudina Nina A.
,
Shishchenko Evgenii R.
,
Joo Oh-Shim
,
Hyung Kyung-Hee
,
Han Sung-Hwan
|
Организации |
1 |
Korea Institute of Science and Technology
|
2 |
Hanyang University
|
|
This paper proposes a new concept for the application of carbon nanotubes to electronic devices. A carbon nanotube (150–200 nm width, few μm length) film grown on a metal sensitized quartz surface was modeled using a two-pole lumped element equivalent circuit consisting of a capacitor, an inductor, and two resistors. The capacitor was in series with the inductor resulting in band-stop filter characteristics with a central frequency of 18 MHz. The reactive subcircuit was in parallel with one resistor and in series with the other. The magnitude of the parallel resistance had a large influence on the efficiency of the reactive elements and the filter quality factor. A two-dimensional carbon nanotube film is expected to be suitable in the design of miniaturized RF filters.